34,333
edits
Changes
→Configuring Scopes at the Command Prompt
<pre>
netsh dhcp server \\winserver-1 scope 192.168.2.0 add iprange 192.168.2.1 192.168.2.100
Changed the current scope context to 192.168.2.0 scope.
Command completed successfully.
</pre>
To list a scope IP address range:
<pre>
netsh dhcp server \\winserver-1 scope 192.168.2.0 show excluderange
Changed the current scope context to 192.168.2.0 scope.
=========================================================
Start Address - End Address - Address type
=========================================================
192.168.2.1 - 192.168.2.100 - DHCP ONLY
Number of IP Ranges : 1 in the Scope : 192.168.2.0.
Command completed successfully.
</pre>
To delete a scope using netsh:
<pre>
netsh dhcp server \\winserver-1 scope 192.168.2.0 delete iprange 192.168.2.1 192.168.2.100
Changed the current scope context to 192.168.2.0 scope.
Command completed successfully.
</pre>
To display the current state of a scope:
<pre>
netsh dhcp server \\winserver-1 scope 192.168.2.0 show state
Changed the current scope context to 192.168.2.0 scope.
Current State of the Scope 192.168.2.0 : Active
Command completed successfully.
</pre>
To add an exclude range to a scope:
<pre>
netsh dhcp server \\winserver-1 scope 192.168.2.0 add excluderange 192.168.2.10 192.168.2.20
Changed the current scope context to 192.168.2.0 scope.
Command completed successfully.
<pre>
To display an exclude ranges:
<pre>
netsh dhcp server \\winserver-1 scope 192.168.2.0 show excluderange
Changed the current scope context to 192.168.2.0 scope.
=====================================
Start Address - End Address
=====================================
192.168.2.10 - 192.168.2.20
Number of ExcludeRanges : 1 in the Scope : 192.168.2.0.
Command completed successfully.
</pre>
