Configuring Ubuntu Linux Wireless Networking

Revision as of 18:55, 22 June 2007 by Neil (Talk | contribs) (Using the Ubuntu Linux Network Settings Dialog)

Revision as of 18:55, 22 June 2007 by Neil (Talk | contribs) (Using the Ubuntu Linux Network Settings Dialog)

Over recent years it has become increasingly common for computers to be connected to local area networks and the internet via wireless connections. Configuring wireless network access on many Linux distributions is still a somewhat complex proposition. True its reputation, however, Ubuntu Linux makes wireless network configuration easy.

Checking for a Wireless Connection

If you are on an open wireless network (i.e it does not use any form of encryption) then it is possible that Ubuntu will automatically locate the network and connect to it. This is because Ubuntu is configured by default with roaming mode enabled. In roaming mode the networking system searches the airwaves for wireless networks it can connect to. If it finds either an open network, or one for which it has the encryption key it will automatically connect. A status indicator in the top right hand corner of the desktop indicates whether or not a network connection is active. The indicator icon shows two computer monitors. If the icon shows a red warning triangle with a white exclamation mark (as below) then there is currently no active connection.

Ubuntu linux network disabled.jpg

Clicking with the left-hand mouse button on the network connection status icon will cause a drop down menu to appear:

Ubuntu linux network menu.jpg

In the above example Ubuntu has located a wireless network called neilandcheryl and shows a moderately low signal strength. The small shield icon next to the network name indicates that this is an encrypted network. It is also possible from this drop down menu to connect to other wireless networks, configure a network connection manually or create a new wireless network.

Configuring a Wireless Network Connection

If the above drop down menu lists a wireless network for which you have an encyption key or passphrase simply click on the network name to invoke the Wireless Network Key Required dialog:

Ubuntu wireless key required.jpg

Select the key type (Passphrase, WEP Hex or WEP ASCII) and the authentication type (Shared key). Having made appropriate selections enter the key or passphrase you configred when you set up your wireless base station and click on the Login to Network button. After a short wait the network connection should be activated. If the connection fails go back and check that you entered the correct settings for the encryption key or passphrase or try using the Network Settings Dialog described below.


Using the Ubuntu Linux Network Settings Dialog

A more advanced network configuration tool is accessible by selecting the System menu at the top of the desktop, choosing Administration and the clicking on Network. The Network Settings dialog lists wired, wireless and modem connections. If no Wireless Connection is shown in the list, check that you have a wireless adaptor card installed into your system. Assuming you have a wireless adaptor installed your Network Settings dialog should appear as follows:

Example.jpg